FAQ

繁 | 簡 | GET A TRIAL | PURCHASE
   


FAQ Home 

Curtain e-locker
Installation Guide
User Guide 

Curtain LogTrace 

Curtain MonGuard

Website Product Page
Curtain e-locker
Curtain LogTrace
Curtain MonGuard 
 
FAQ No.:00207 
Category:Advanced Settings; Curtain Admin 
 
Question:

How to disable protection temporarily?

 
 
Answer:The function of Disable Protection provides the flexibility to administrators to allow workstations/users under particular policy group to access Protected Zone without e-locker protection. In general, it is not recommended to enable this function because it may cause leakage of sensitive files. However, sometimes administrators may need to disable e-locker protection temporarily. You may create a Policy Group with this function enabled. When you want to disable e-locker protection to workstations/users, you can simply assign them to this control policy group.

Steps to disable Curtain e-locker protection:
1. In Curtain Admin, select a Policy Group and right-click to select "Properties".

e-locker data loss prevention(DLP) - Properties

2. Select "DISABLE PROTECTION on protected zones".

e-locker data loss prevention(DLP) - DISABLE PROTECTION on protected zones

3. Click OK to confirm.

If a workstation/user is disabled e-locker protection temporarily, "FULL ACCESS" will be shown in the title bar of Curtain Client as below.
e-locker data loss prevention(DLP) - FULL ACCESS

4. Done.

If you want to remove the entire Curtain e-locker system, please refer to FAQ 00029 - How to uninstall Curtain e-locker system in the future? any procedures or guidelines